Furnace Forge Co logoFurnace Forge Co

Furnace Repair

Commercial Furnace Repair in Boise: Clear Diagnosis, Local Owner

Furnace repair for Boise shops, offices and small commercial buildings: rooftop and indoor gas units diagnosed with airflow and combustion checks.

  • ✓Owner-Operated
  • ✓Locally Owned
  • ✓Based in SW Boise

A commercial furnace that will not heat usually has a failed igniter or flame sensor, a seized blower motor, or a tripped safety switch caused by poor airflow. This page covers light commercial heating in Boise, such as small retail, offices and shop units. We repair heating equipment, not industrial process furnaces or foundry equipment. Call (208) 683-7054 to describe the unit.

Typical light commercial problems

  • Rooftop units short cycling because of undersized or collapsed return ducts.
  • Blower motors failing after continuous run hours and dust ingestion.
  • Igniters and flame sensors worn from frequent on/off cycles.
  • Gas pressure or flue problems on older units that need a combustion check.

What a technician checks

  1. Thermostat or building control signal and 24-volt power.
  2. Gas pressure and combustion readings.
  3. Heat exchanger visual inspection for cracks.
  4. Blower motor amps, wheel and static pressure.
  5. Flue and venting condition.

Repair or replace

When a unit is old and repair costs keep returning, a written findings report helps you plan the replacement. Manufacturer data plates give the age and model for parts matching. For gas units, see gas furnace repair.

Technician insight

In Boise 83709, the thing that catches most people out with Commercial Furnace Repair is how quickly older rooftop units on flat-roof buildings lose efficiency once the first cold snap hits and short cycling begins from undersized returns.

Rooftop Unit Failure at Strip Mall

A retail tenant near Overland Road reported no heat on a December morning. Inspection found a seized blower motor and restricted return air from a collapsed flex duct. The motor was replaced and the duct run was rerouted with rigid pipe to restore proper airflow and prevent repeat failure.

Commercial Furnace Repair Services We Offer

✓Heat Exchanger Inspection

Visual and camera checks for cracks before combustion gases reach the workspace.

✓Blower Motor Replacement

Matched horsepower and speed ratings for rooftop and indoor commercial units.

✓Ignition System Repair

Diagnose igniters and flame sensors on frequently cycling equipment.

✓Gas Valve and Pressure Checks

Check manifold pressure and valve operation on older equipment.

✓Duct and Airflow Corrections

Find restrictive returns and duct runs that cause high static pressure.

Commercial Furnace Repair Cost in Boise, ID

Service Typical Range What Affects It
Commercial Furnace Diagnostic $125–$225 Includes combustion testing; waived if repair is approved same day
Blower Motor Replacement $450–$950 Varies by motor horsepower and rooftop access difficulty
Heat Exchanger Repair $600–$1,400 Depends on unit size and whether full replacement is required
Ignition System Service $175–$350 Covers igniter and sensor replacement on most commercial models

Ranges are typical for Boise, ID and confirmed with an exact written quote before any work starts.

How it works

  1. 1

    Site assessment

    The technician reviews unit age, service history and symptoms at your building.

  2. 2

    Combustion and airflow testing

    Gas pressure, combustion readings and static pressure identify the root cause.

  3. 3

    Component repair or replacement

    Parts matched to the existing equipment are installed to local code.

  4. 4

    Final verification

    The system runs multiple cycles and readings are rechecked before the visit ends.

Pricing

Cost depends on unit size, access and parts; the price is explained after the inspection and before work starts.

Furnace Forge Co — Furnace Repair in Boise

Good to know

Commercial Furnace Repair — FAQs

Still have questions? We're happy to talk it through.

(208) 683 7054
+ Do you repair industrial or process furnaces?
No. We repair heating furnaces in homes and light commercial buildings, not foundry, induction or other industrial process equipment.
+ Can you work on rooftop units?
Yes, rooftop and indoor gas furnaces serving small commercial spaces.
+ What should I have ready when I call?
The unit location, brand and model from the data plate, and what it does when it fails.
+ Will I get a written report?
Yes, a summary of findings and recommendations, including whether repair or replacement makes sense.

Business hours

Need help? Call us now

Call Furnace Forge Co and describe the problem. We provide upfront quotes and workmanship you can inspect on every furnace repair and maintenance job in Boise 83709.

Call now Get help